Page 2 of 2 FirstFirst 12
Results 16 to 17 of 17

Thread: Starting line up

  1. #16
    Join Date
    Jun 2010
    Location
    twomiles from the "peak of Ohio
    Posts
    5,141
    I just picked up four planes to rehab, and a saw, this morning..
    IMG_2238 (640x480).jpg
    One steel, one iron,and..
    IMG_2239 (640x480).jpg
    A pair of "Goldenberg" woodies.....1-5/8 wide irons....the saw?
    IMG_2235 (640x480).jpg
    26" long, 8ppi, skew back crosscut, by Richardson Bros.
    IMG_2236 (640x480).jpg
    $9 total for the morning....

  2. #17
    Join Date
    Jun 2010
    Location
    twomiles from the "peak of Ohio
    Posts
    5,141
    As for that #900 Milllers Falls plane...
    IMG_2246 (640x480).jpg
    Rear handle has been repaired..
    IMG_2244 (640x480).jpg
    Iron has been sharpened, flat on the back, chipbreaker mated to the iron. Edge has a bit too much camber, will correct on the next sharpening.
    The little block plane..
    IMG_2247 (640x480).jpg
    Was unable to remove any of the knobs....rest of the plane cleaned and the blade sharpened...
    IMG_2248 (640x480).jpg
    Sole is flat enough, for a block plane..
    IMG_2249 (640x480).jpg
    And, it do make shavings....

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •