Ridgid r4512 fence higher than table on the front of the saw

[Michael Donahue]

The "T" part of my fence (don't know the right term!) is higher than the table by maybe 1/16" in front. I've seen a number of threads about fence alignment but I can't seem to find a fix for this. I'm worried that this means grooves and dados won't be a consistent depth and it might be factoring into other alignment issues. Any suggestions?

[Randy Viellenave]

Might try to loosen the rail and move it down. The holes in my 3650 were big enough to affect a small movement, and I did it a few times when moving. You will still need a few thousandths under the fence. I used a sheet of paper folded in quarter as a spacer, never had issues with it. If the holes are not loose enough, you may have to open them up a little bit.