poor mans plywood storage

[Bob Cooper]

i build a lot of cabinets for the house so plywood is typically either 48" wide or 24" wide when i store it. I've been leaning it against the walls or flat on the garage floor outside my shop. My shop is attached to the garage.

This weekend i finally decided i needed to do *something* about the storage or the plywood. I looked at various approaches and finally settled on something very simple and probably obvious to ya'll but thought i'd share anyway.

This was very simple, cheap and quick. I do know that there's still the issue of getting to stuff in the back but for me that's not much of an issue
. IMG_9386.jpgIMG_9383.jpg

[Adam Herman]

You really stick to KISS. I often only have a few sheets at a time, this would be perfect.
i may even make an arm that can hold the tops and cut sides so that i can slide a sheet out the side from the middle.

Nice work.

[Yonak Hawkins]

Yeah. There's nothing wrong with that. It gets the job done.