And a few screws.
IMG_2455 (640x480).jpg
Well, there is one cleat.....turn this over, install the cleat into the vise
IMG_2456 (640x480).jpg
Add the other cleat on the end...
IMG_2457 (640x480).jpg
There is something missing in the 2 x 6..
IMG_2458 (640x480).jpg
needed to "refresh" this track, a bit...
IMG_2465 (640x480).jpg
#78 worked just fine. Clamped a bit of scrap, and marked a line..
IMG_2461 (640x480).jpg
And get the "chuting plane" out of the til..
IMG_2462 (640x480).jpg
Stanley No. 5-1/2, type 17....
Check with a square..
IMG_2467 (640x480).jpg
Works for me. Angles are done by adding the required wedge against the stop cleat.
This is more for cleaning up cuts made at the bandsaw......mitre saw really doesn't need this set up.