I am a beginner at turning. I bought one of these back scratchers for a gift:
http://www.packardwoodworks.com/Merc...Category_Code=
I turned a purpleheart but handle only used a different profile. The hole in the handle is 7/16" diameter and 4 1/2" deep. It is a snug fit for the scratcher.
Would it be better to use epoxy or CA glue. I do not want to put to much adhesive in there and cause a problem.
Is it better to put a little adhesive in the hole away from the top to avoid it coming out. The handle is finished and do not want to mess it up.
Thanks