Good afternoon or morning everyone. I have noticed this twice so far and I'm alittle puzzled. I had an order come in for 50+ leather key chains and instead of doing them one at a time, I made a template out of acrylic. I placed the template in the machine and then filled it with the key chains. I setup the artwork in Corel using the template that I had just cut. You with me...? When I ran the job, that the engraving on the key chains on the left side was a little to the left.
I didn't think too much about it b/c the tolerances weren't that tight on key chains but now I'm working on some tiny metal parts where the tolerances are super tight and I'm trying to do 500 at a time. I'm seeing the same thing on this as well. I can compensate by moving the parts around in corel but its strange that the laser will cut the template and then its off.
Has anyone else noticed this and I'm sorry if I'm not being clear.