I have a 16" wide and 60" long workpiece that will have bevels on both 60" edges (front of a bench). Is there any way to safely make the bevel on a right tilt saw? I only have about 12" of purchase on the left side of the blade.
I already made one of the cuts. I did it by putting the fence on the right and cutting only a small bit off (less than one inch). But I've taken a bevel kickback before and have the scar to prove it. So I'm leery of doing any more like this.
Any advice? Thoughts I've had include using a 2x4 as a temporary fence (clamped to the table since I have more space but can't engage the actual fence) or just use a circ saw.