Go out to the shop, pick out the seven most used planes, line them up on your bench, and take a picture or two.

Mainly the daily users, the ones you use every time in the shop.....then post a little bit about them. Just seven planes, everyday users.

Something like this...
IMG_2576 (640x480).jpg
There is a No. 0-7 for the jointer stuff..
There is a #5 for the jack plane stuff
There is a junior jack plane, for the smaller jobs
There is a #4 smooth plane for...well, smoothing things out
There is a Combo plane, for when things need to get "groovy", or wear some "beads"
There is a 60-1/2 Low angle block for block plane chores...

There are others...but these are my users. others will fill in as needed, but these are the "core group" in this shop...

How about yours?