Performax engineers are knuckleheads.

[keith micinski]

Need to spell check these posts a little better late at night before I hit reply apparently. That last one is pretty rough to read. My Abranet came in today so it might happen tomorrow afternoon if things go well on a bathroom remodel I am working on.

[keith micinski]

IMG_0115.jpg

Well unfortunately had a few setbacks today. The two clips size difference in size is substantially more then I thought it would be. The clips can only be switched if you redrill the hole on the outside edge but even that would be hard to do because it’s an 1/8 closer then it needs to be and by the time you drill it out I’m afraid it would be to close. You would probably have to move the clip in board on the drum some which I think would work but I don’t have enough interest and time right now to do that. I then thought well let’s go ahead and switch the drum end for end but my spring clip pliers decides to break on me as I was trying to remove the inner one so that shot this whole process down.