Rail/Stile Bit - where to get

[Larry Fox]

Does anyone know where I can buy a rail/stile bit set that will cut the profile shown below? I have tried all the usual suspects (CMT, MLCS, Freud, Amana) with no luck. An artist I am not so the image is a bit crude but I think it gives the idea. It is a step down, angled flat field, step down, another angled flat field, with another step down to the panel.


Apologies if this is a double post, the first one just sorta "vanished" when I went to post it.



Thanks in advance for your time. . .

[Dick Bringhurst]

The link doesn't work. Dick B.

[Larry Fox]

http://www.sawmillcreek.org/attachment.php?attachmentid=25743&d=1131477388

Sorry - first post with an image. I hope it works this time.

[John Hemenway]

Well, Larry it's still a busted link.

Try again?

[Dan Oliphant]

Larry,
Take a look at Whiteside router bits http://www.whitesiderouterbits.com/c...atalogHome.asp