Good day to all!
I purchased a Forrest WW2 blade at the last WW Show I attended and thought that it would be a good time to check the alignment of my miter slot to the blade. Forrest recommends <2 mils front to back (of the same tooth on the blade); I have about 5.5 mils (as measured with a TS-Aligner).

Before I just go crazy and loosen the nuts holding the table on, do you have any advise for me? I know this isn't rocket science but surely there must be some secrets out there.

Following getting this set, I will then tackle the fence to miter slot to the fence, but one thing at a time.

Thanks!
Warren White