Results 1 to 3 of 3

Thread: New Lathe

  1. #1
    Join Date
    Dec 2005
    Location
    Hamilton, Ohio
    Posts
    57

    New Lathe

    I am looking at getting a lathe, I do not know a lot about them and was looking for an entry level one. I seen in a catalogue the new Grizzly GO462 16in x 43in with a 2hp motor. Does anyone know if this would be a good starter lathe? Is there any features it does not have that I should look for? I have bought from Grizzly before and was very happy with what I got so that is why I am leaning towards them on a lathe.
    "The good guys wear plaid"

  2. #2
    Hey Roger...take a look at this recent thread. Good discussion about that lathe. http://www.sawmillcreek.org/showthread.php?t=31615
    ~john
    "There's nothing wrong with Quiet" ` Jeremiah Johnson

  3. #3
    Join Date
    Jun 2005
    Location
    Texas, ILL.
    Posts
    1,202
    Hi Roger, there is a discussion on the lathe you have inquired about, on pg. 2. It's under Hmmmmmm I wonder.

    Bill.>>>>>>>>>>>>>>>>>>

Similar Threads

  1. Safety on the Lathe (long with pictures)
    By Bill Grumbine in forum Turner's Forum
    Replies: 18
    Last Post: 02-19-2006, 3:45 PM
  2. What lathe? No room" (JETMINI)?
    By roy knapp in forum Turner's Forum
    Replies: 11
    Last Post: 01-09-2006, 4:52 PM
  3. Powermatic 3520A is on its way!
    By Kent Cori in forum Turner's Forum
    Replies: 13
    Last Post: 11-27-2005, 5:49 PM
  4. VS Motor for Mini Lathe for under $125
    By Mark Kauder in forum Forum Tech Support
    Replies: 6
    Last Post: 12-13-2003, 5:21 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •