I built a mite sled back in the fall to go along with my cross cut sled. The miter sled is almost identical to the one Jim Becker is using in his Candle Holder Table thread.
After I built this I used it on several occasions, it made perfect mating miters. It hasn't been used since November. Yesterday I went to use it and was suprised to find that it will almost not go thru the slots without pushing it hard. Definitley can't use it to cut wood with it safely and probably isn't accurate that way either. Anything I can do to straighten this out or is it doomed for the scrap bin?
Thanks,
Corey