OK, you've just glued up a panel with your favorite yellow glue. How long do you leave it in the clamps? How long till you start working it flat, square etc?
I'm always afraid i'll stress it too soon and weaken the joints.
Brian
OK, you've just glued up a panel with your favorite yellow glue. How long do you leave it in the clamps? How long till you start working it flat, square etc?
I'm always afraid i'll stress it too soon and weaken the joints.
Brian
The significant problems we encounter cannot be solved at the same level of thinking we were at when we created them.
The penalty for inaccuracy is more work
I wait until the big blobs of squeeze-out are hard enough to scrape without making a mess:
they take a lot longer to dry than the thin layer inside the joint.
Yoga class makes me feel like a total stud, mostly because I'm about as flexible as a 2x4.
"Design"? Possibly. "Intelligent"? Sure doesn't look like it from this angle.
We used to be hunter gatherers. Now we're shopper borrowers.
The three most important words in the English language: "Front Towards Enemy".
The world makes a lot more sense when you remember that Butthead was the smart one.
You can never be too rich, too thin, or have too much ammo.
With PVA, you can usually un-clamp after a few hours, but the panel will need 24 hours to fully cure. Like Lee, I scrape the squeezings "sooner" rather than later to reduce the incidence of very hard glue on the surface of the workpiece...I do it even before un-clamping, usually about about the half-hour to 45 minute mark if I actually can remember to do so.
--
The most expensive tool is the one you buy "cheaply" and often...
4 hours. To test your glue? Do this:
Take a scrap piece of 3/4" hardwood plywood.
Take a scrap piece of 3/4" wide hardwood (strip of solid wood)
Spread some glue on "just the solid wood".
Apply said solid wood scrap to the edge of the plywood.
Clamp and allow to set for 20 minutes.
Remove said clamps.
If yours works like mine did? You'll have to CHISEL off the wood from the plywood.
True story and I've got pics to prove it from a past post here on SMC.
I think the "under my breath" statement that night was: Wait 24 hours before stressing joint. Huuh-rumph!!!!!!!
Thanks & Happy Wood Chips,
Dennis -
Get the Benefits of Being an SMC Contributor..!
....DEBT is nothing more than yesterday's spending taken from tomorrow's income.
Depending on temputer.
I use titebond original.
If its 70 degrees, I pull the clamps in 15 minutes, scrap off excess, and run them through the planer.
same here...02 todOriginally Posted by Steve Clardy
TO WHOM IT MAY CONCERN; I ACCEPT FULL LEGAL RESPONSIBILITY FOR MY POSTS ON THIS FORUM, ALL POSTS ARE MADE IN GOOD FAITH CONTAINING FACTUAL INFORMATION AS I KNOW IT.