After 2 1/2 weeks I finally have the MM16 in the basement and running. The first picture is the saw right after delivery. It would not fit in the 7' door so I had to round up some friends to help me get it off the pallets and into the garage. I took the table off to lighten the load by about 90 lbs. The 2nd pic is the saw in the garage with the table off. I spent some time figuring out how to get it in my basement, it is top heavy and wieghs about 375 lbs without the table. I took the motor off to lighten the load by about another 60 lbs. Pic 3 shows the saw attached to an appliance dolly along the spine with a block and tackle rig to lower it to a horizontal position along the spine. Pic 4 shows it lowered with a 4 wheel dolly at teh top of the appliance dolly. This made it easy to roll around and to pull it up ramps using the same block and tackle, into the back door of the house. I then moved the block and tackle to the top of the saw and tied it to my truck in the back yard. I put plywood ramps on the basement stairs. A friend and I then lowered the whole thing down the stairs into the basement. It all took about 45 minutes with no problems or hurt backs.