Page 3 of 3 FirstFirst 123
Results 31 to 36 of 36

Thread: Platters 101

  1. #31
    Join Date
    Jan 2005
    Location
    San Antonio, TX
    Posts
    918
    Andy, I just read your tutorial. It was very helpful, as I will be attempting one in the future. Thanks for your time and effort.
    Ed

  2. #32
    Join Date
    Feb 2003
    Location
    Nashville, Georgia
    Posts
    1,909
    Andy, your help was very well done. You are an asset to the Creek.
    Glenn Hodges
    Nashville, Georgia

    "Would you believe the only time I ever make mistakes is when someone is watching?"

  3. Yes Mr. Hoyt, that will certainly do just fine!

    Thanks for that, I need to make some of them.

    My wife wants me to make a cake platter thing, so I would be a platter with a stand, no?

    Cheers!

  4. #34
    Stu: I want to let you know now that this comes from the deranged mind of a professional cake decorator.

    Does she want a cake platter, or a cake turntable? I assume this means she will be presenting round cakes, and not sheet or shaped cakes.

    Overall, the answer to your question is yes. If it's just a platter, then you don't need much of a stand---just enough to raise the platter off the surface of the table. I would also recommend looking at the domes she might use. If there's a nice glass dome, turn the platter to fit. If she's not too worried about seeing through the dome, then I'd say go ahead and turn a dome to match the platter.

    If she's looking at a turntable, then that brings a whole slew of other variables into the mix. I could go on and on about my perfect turntable. For a simple one, however, you should have a nice, thick, sturdy base with a wide foot, with as much mass in the base as possible. The stem of the base will definitely need to be sturdy and thick. The base and platter would be two separate pieces, as you would be joining the two with (preferably) a thrust bearing (although a greased dowel fitting would do in a pinch).

    PM me if your wife is seriously into cake decorating and you want ideas for the "perfect" turntable.
    That's not a light at the end of the tunnel; It's a naked singularity.

    Henry C. Gernhardt, III

  5. #35
    Join Date
    Feb 2006
    Location
    Bedford County, Virginia
    Posts
    2,325
    Wow. That's a great tutorial Andy. Thanks for putting in the time and effort. I'm "bookmarking" it for future reference.
    Mark

  6. #36
    Very cool tutorial.... I may just have to give that a try (albeit w/thicker wood).

Similar Threads

  1. Platters class 201
    By Tom Jones III in forum Turner's Forum
    Replies: 15
    Last Post: 09-18-2006, 10:21 PM
  2. Plates or Platters
    By Bernie Weishapl in forum Turner's Forum
    Replies: 4
    Last Post: 08-31-2006, 12:13 AM
  3. Incredible platters!
    By Forrest Price in forum Turner's Forum
    Replies: 5
    Last Post: 08-11-2006, 12:58 AM
  4. Material for platters?
    By Tom Jones III in forum Turner's Forum
    Replies: 14
    Last Post: 07-26-2006, 10:16 AM
  5. Enough PLATTERS already!
    By Bruce Shiverdecker in forum Turner's Forum
    Replies: 14
    Last Post: 10-17-2005, 9:16 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •