Results 1 to 3 of 3

Thread: Delta 34-444 switch replacement

  1. Delta 34-444 switch replacement

    I've got a 1990 Delta Contractor's saw (34-444) and would like to replace the toggle power switch. I've been thinking about the Grizzly magnetic switch - are they pretty easy to install?

    Thanks in advance,
    Scott Patterson

  2. #2
    Join Date
    Mar 2003
    Location
    Southport, NC
    Posts
    2,924
    Magnetic switches need to be matched to the motor. What Grizzly switch are you referring to?

    I have the same saw and replaced the small toggle switch with large button switch sold for use on a router table. I've seen them in a couple of on-line woodworking tool catolog sites.
    Howie.........

  3. I believe it was the G8291. My saw has the Delta 1 1/2 hp single phase motor.
    Thanks,
    Scott

Similar Threads

  1. Failed switch on Delta 6in Jointer
    By Duan Packard in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 06-04-2006, 8:51 PM
  2. Replacement Switch for Craftsman TS Needed
    By Mark Hulette in forum General Woodworking and Power Tools
    Replies: 15
    Last Post: 08-27-2005, 1:54 PM
  3. Delta 6" Jointer On/Off Switch Problem
    By Kurt Aebi in forum General Woodworking and Power Tools
    Replies: 4
    Last Post: 11-16-2004, 7:45 AM
  4. Exist mag. switch on Jet 14" BS wired for 220V?
    By Dominic Greco in forum General Woodworking and Power Tools
    Replies: 9
    Last Post: 01-27-2004, 12:45 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •