Results 1 to 3 of 3

Thread: Looking for a member or wood source

  1. #1
    Join Date
    Dec 2003
    Location
    Delton,Michigan
    Posts
    668

    Looking for a member or wood source

    i have an acquaintence that is looking for a quality wood source near colorado springs area. are there any members or does anyone know of a good wood source near there. he is now serving in the air force in afganistan,, so he is alittel to far away to look for him self thanks for any help.
    If in Doubt? Build it Stought!

  2. #2
    Larry,

    I'm near Colorado Springs (just up the mountain about 30 miles). For this area my preference is C O Lumber Specialties 719-389-0100. They are 3636 N Stone Ave. Take the Filmore exit from I-25 and go East, turn left onto Stone.

    They sell unfinished furniture (not very good quality IMHO) and S2S wood. I haven't found any place that sells true rough wood in this area, but their prices seem reasonable and they have a large selection.

    Let me know if your friend has any specific questions and I'll see what I can do to help. I served 8 years in the Air Force myself so I'm happy to help out a fellow airman.
    Jeremy Gibson

  3. #3
    Join Date
    Dec 2003
    Location
    Delton,Michigan
    Posts
    668

    look at the classified section.

    thanks jeremy look in the classified ad section his name is don baer. i talked with him friday ,,from over there he had a few free mins.. he is gettin out in feb.
    If in Doubt? Build it Stought!

Similar Threads

  1. Turners Glossary...?
    By Stu Ablett in Tokyo Japan in forum Turner's Forum
    Replies: 15
    Last Post: 05-21-2008, 1:39 PM
  2. Taking Wood Dust More Seriously (Long)
    By lloyd morris in forum General Woodworking and Power Tools
    Replies: 26
    Last Post: 05-28-2006, 11:22 AM
  3. Wood Source in Canada?
    By James Farrow in forum General Woodworking and Power Tools
    Replies: 6
    Last Post: 02-05-2006, 10:03 PM
  4. Wood A/C vent register source
    By David Duke in forum General Woodworking and Power Tools
    Replies: 9
    Last Post: 10-21-2005, 2:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •