I have mixed colored chalk dust in epoxy and had good results.
I have mixed colored chalk dust in epoxy and had good results.
No PHD, but I have a DD 214
While epoxy is in a can preventing corrosion it is undisturbed, it is not on a cutting board getting small particles in whatever you happen to be cutting at the time, besides when they say somthing is safe that is not always the case.
Last edited by Darrin Vanden Bosch; 03-24-2011 at 10:23 AM.
I bought a Pantagraph (sp?) from Milescraft at Tampa woodworking show last weekend. The guy doing the demo suggested coating material being routed with Thompsons deck oil before routing. This will apparently adequately seal the wood around the routed area for further finishing