Bandsaw work light--looking for ideas

[Bill Dufour]

I am using a goose neck with an LED bulb. Note many led bulbs run 120-240 volts. I mounted mine by removing the bar that the holds the blade guides. Drilled and tapped a hole in the top end of the bar. This way the lamp stays aimed at the cut line as the guides are moved up and down.

[Erik Christensen]

I got a super nova for my lathe and it works so well it spends a lot of time on the bandsaw, with the mag switch it takes longer to hook up the DC hoses than to install & position the light..

https://woodturnerswonders.com/collections/lamps

[Brian Holcombe]

I mounted a Tolomeo lamp to the wall, it has about a 4’ swing.