Well I worked on my bench some more today & this evening.

I got the bench composite top banded in 13/16 thick Poplar 4" wide & got the Masonite cut to size. The top is made of a sub-straight of 1" plywood with 3/4" particle board on top of it & the final cover of 1/4" Masonite.

Tomorrow I hope to route a slight round over on the top edge & do a little finish sanding on the banding & the apply Watco fruit wood stain to the banding. This is not a fancy bench but it is heavy & nice a solid & flat & 36"x 66"to be use as a bench/table-saw off-feed table

I also hope to sell my contractors table-saw so I can go buy a cabinet saw