Hope this doesnt sound too dumb, but I cant seem to find an answer.
I have a hvlp accuspray conversion gun that I have set per the instructions and have had good results with it.
It sprays very similarly to other air guns and puts out a fair amount of finish, and as such needs a fair amount of masking for overspray etc.
My question is this: I have seen one demo and another on tv showing a turbine hvlp, which is barely dribbling out paint. It is very low pressure and takes quite a while to paint. Since it is so little coming out, very little masking is needed and it could easily be used to paint a installed door etc.
Should my conversion gun act like the turbine or more like a conventional gun? Im not sure if I am setting it right even though I get good results. I would like to cut down masking if possible and want to learn to do this right in any case.
Any advice would be much appreciated.
thanks,
Stevo