Hi All,
I need to cut some wedges about 3" wide with a taper of 15deg, these are about 9" long. What would be the safest way to do this?
These will be mounting blocks for retractable casters for my workbench.
Thank's,
Dick
Hi All,
I need to cut some wedges about 3" wide with a taper of 15deg, these are about 9" long. What would be the safest way to do this?
These will be mounting blocks for retractable casters for my workbench.
Thank's,
Dick
I'm sure that with a little planning, a jig (or combination of jigs) to use with your tablesaw wouldn't be that hard to work up.
There's one in every crowd......and it's usually me!
Sounds like a job for the band-saw!
Bandsaw and then joint the sawn surface if required or hand plane, belt sand, etc.
"A hen is only an egg's way of making another egg".
– Samuel Butler
I do wedges on the band saw.
--
The most expensive tool is the one you buy "cheaply" and often...
All,
Thanks for your ideas.
Dick