I've never worked with MDF before and had a couple of questions for those that have.
Does it hold a routed edge as well as wood? Say an ogee edge or even a nice roundover. Will it be retained or does it crumble away over time? Can I make a tongue and groove joint and glue it up like wood?
Can it be used for something like drawer sides where the screws that attach the slides will be only 1/2 inch or so long. I've been using 1/2 inch plywood and wondering if MDF would be easier to work with.
The local BORG sells MDF and next to it is "pressed hardboard". Looks the same. Any differences?
Thanks!