perforating ZCI to improve dust collection?

[Jason Beam]

That's a good start, Bruce. If my radially uniform tuit ever comes in, that's exactly where I plan to begin. I'm hoping to come up with a way to mount something that'll tilt and raise/lower with the blade. Tilt, at least. I may not need to raise/lower with it.

[Noah Katz]

I don't see how any kind of holes you put in the ZCI could allow enough airflow tio be effective.

[Alan Greene]

Gil,
Here is how I set up my Shark Guard to work with my DC. The DC connects to a 4" HVAC duct from the Borg that goes under my out feed table to the saw connection and then continues on and up the wall and across the ceiling where it drops down with flex hose. This saves me a lot of time and it picks up the dust pretty well. I can control the flow with a blast gate at the end of the drop down hose. It is not ideal but will work until I get the Cyclone. I can also use it for the router table extension. I hook it to the Air cleaner to get it out of the way when I am using the my sled.

[glenn bradley]

What type of tablesaw are you useing ? Bench ? Contractor ? Hybrid ? Cabinet ?

Hybrid here.