Hi,

I did a search on here and woodnet for a crosscut sled used on a router table but didn't come up with anything. So has anyone used a crosscut sled on their router table? I work with different materials often and I've been using my sliding table to crosscut pieces and then router down the edges. But the angles don't always come out right and its hard to edge up a 6' *2' piece when your doing it on the 2' side without a sled. I've got some ideas but wondering if anyone has tackled this already. I'm still thinking about how to incorporate using different router bits but still support the work piece as close to the cutter as possible.

I just order a bench dog promax table and lift and plan to attach a long table to the left of it. I'm strictly going to be using this for crosscutting so I was thinking of lowering the promax with respect to the extension tables and leaving the sled on top of the promax on a permanent basis.

Any ideas?