I have the Orion built Craftsman Pro 6" jointer. Looks about like any other common 6" jointer. I've never used a jointer, and the directions are pretty weak concerning actual operation. I believe I am adjusted correctly now. (outfeed table level with cutter blade). I really don't know how to feed the board, and I am getting a little inconsistency in the cut, to include a bit of snipe at the end of board. OK edge overall, but not good enough for a glue up. Enough of the cut is good to make me think it is me, and not the jointer that is screwing up. Say I am feeding a 1x6 24 inches long for the sake of discussion. Apply pressure to board against the infeed or outfeed table? And how big of a cut should I take. Any other tips? Thanks