Results 1 to 4 of 4

Thread: Making a "lacquer glaze"

  1. #1

    Making a "lacquer glaze"

    Can you mix some oil based stain with lacquer to make a glaze? I'm not sure about compatibility. Its not something I plan on applying and wiping off like you do with some glazes. Rather I want to spray several coats over an already stained surface, maybe it would be more like a toner then. Anyway, whatever you call it, can you do it?
    Thanks, Chris

  2. #2
    Not usually. Some oil based stains can be used but it's a gamble as to compatibility.
    You can use alcohol soluble dyes, plain pigments, universal tints like Huls 844 colorants, japan colors, etc.

  3. #3
    Join Date
    Mar 2003
    Location
    SE PA - Central Bucks County
    Posts
    65,685
    No, do not mix and oil based product with lacquer. Universal tints are probably the safest, etc., as per Bob's post.
    --

    The most expensive tool is the one you buy "cheaply" and often...

  4. #4
    Join Date
    Apr 2004
    Location
    Livermore, CA
    Posts
    831
    Transtint will go into solvent based lacquer as a toner.

    Glaze and toner are similar but different. Here is one illustration of the differences:

    Glaze: Often used to give an aged appearance by filling in recesses/crevices with a dark finish. Makes it look like years and years of crud build-up in those recesses.

    Toner: Often used to adjust color by adding a bit of warmth or perhaps coolness.

    So...glaze is often applied in a manner that gives more color to certain places and less color to others while toner is usually applied to give the same amount of color throughout. With a glaze, you usually want a slow-drying medium to allow you to apply and then wipe-off from high spots, similar to stain. With toner, you usually want something that will dry quickly so you can apply mutliple coats or get done sooner.

    The above is just one possibility. Many use glaze and toner in different ways.

    As always, if in doubt test it. Add some oil-based stain to your lacquer and test it out on some scrap. If you are just worried about compatibility between the stain and lacquer, you don't need to apply it to the same wood as the furniture you're finishing....any scrap will do. If completely incompatible, you may know as you mix them together.
    Tim


    on the neverending quest for wood.....

Similar Threads

  1. making pen boxes - how?
    By Frank Fusco in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 06-26-2006, 12:27 PM
  2. making project match the house
    By Dick Phillips in forum Project Finishing
    Replies: 1
    Last Post: 01-15-2006, 3:37 PM
  3. Making a pattern
    By jon harriman in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 01-04-2006, 3:10 PM
  4. Question on making a cut
    By Steven Kamp in forum General Woodworking and Power Tools
    Replies: 19
    Last Post: 12-20-2005, 8:52 PM
  5. Making a Better Coping/Dovetail Saw
    By Bob Smalser in forum General Woodworking and Power Tools
    Replies: 7
    Last Post: 10-08-2004, 4:06 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •