My grandmother always said " If you don't ask, you will never know." So here it goes, how do you use a dial indicator to check for run out on a drill press? Thanks in advance.
My grandmother always said " If you don't ask, you will never know." So here it goes, how do you use a dial indicator to check for run out on a drill press? Thanks in advance.
Somehow mount the indicator to the DP table with the "pointer" zeroed out against the smooth part of a drill bit and then spin the chuck by hand.
Brian
The significant problems we encounter cannot be solved at the same level of thinking we were at when we created them.
The penalty for inaccuracy is more work
Sometimes it is hard to get the shank to stick out far enough to get the indicator on. Some kind of ground stock is the alterative.
Gary
Mark Dugenskie's video "Mastering Woodworking Machines" shows how to do this with dial indicator, or feeler gauge.
A round shank screwdriver will also work but you should re-chuck a couple times in case it isn't perfectly straight.
The significant problems we encounter cannot be solved at the same level of thinking we were at when we created them.
The penalty for inaccuracy is more work