Utility Card Handle Question

[robert hainstock]

When drilling from each end, meeting in the center will invariably never happen - even over a short distance. With a hole that long? Impossible as far as I know.

Much better to drill from one end and then turn the handle with some cone centers in the holes to line it up.

That has been my expierence in the past with much shorter work. Yours is good advice, and I thank all again. I will report with details when I solve the riddle

[robert hainstock]

Robert, I bought an electrician's 5/8" drill bit once; 18" long... a bit of the right diameter, with an extension... might do fine.

AAAAAAAAA bit with ectension is what I will probably go with. Thanks!