While making some raised panel doors for a built-in I realized the difficulty of stablizing the door panel within a Rebel router table that I have use successfully in the past for all item except the "raised panel" which requires horizontial and vertical holddowns for an accuarate finished door. Given the diam. of the panel cutter of 3" I can not lower the cutter enough to take several passes in the panel. Consequently I have tried, unsuccessfully, to raise the table and minimize the individual cut. Better but still not acceptable. Any help would be appreciated. I read with interest the info. on router tables vs. shapers but this project requires only several doors and nothing of a similar nature in the horizon. The shop fox looks like a solution but the budget would not allows it.