I stumbled upon this so thought I'd share. The job is cutting 150 items (.9" circles with holes) out of just 3M 468MP adhesive. I had 2" tape which x24" is perfect for 50. I applied it to scrap vinyl release liner, then taped it onto a scrap of 1/4" acrylic. I was expecting trouble, figuring they would blow out the exhaust, but it turns out that at my settings they stuck to the acrylic just enough to keep from blowing off yet easily be removed with tweezers. As you can see on the last two, the item pulls off leaving the
inside waste bits.
On my 45 watt Epilog I used speed 35, Power 35, frequency 750.