I picked up one of these and have a couple questions I don't see answered in the manual -- looking for comments from those who are a bit more familiar with this machine than I...
1. see photos below; there does not appear to be a method to adjust the fence left/right. Is it wrong to assume the cutout on the fence should be centered over the cutterhead opening? The cutterhead has plenty of clearance -- it just seems odd.
2. should the fence drag across the outfeed table like it does? it seems to be scratching it up pretty good. I suppose I could raise the fence support casting but the manual says the fence support casting should be flush/even with the outfeed table. Mine arrived with the fence support slightly (maybe 1/64") proud of the outfeed table.
Thank you.
Reply With Quote