Results 1 to 4 of 4

Thread: Corel Paint question

  1. #1
    Join Date
    Dec 2005
    Location
    Pinckney MI
    Posts
    128

    Corel Paint question

    Is it possible to add an area to a cropped photo? I have a picture that crops the shoulder off of a subject. It looks a bit odd and I'd like to give him a shoulder. I've tried cloning but since the original picture cuts that portion off, I'm not able to add to it.

    Can this be done?

  2. #2
    Join Date
    Oct 2005
    Location
    Moreton, Wirral, UK
    Posts
    3,287
    I've sent you a private message
    Epilog 45w Helix X3/X5 Corel Microflame Generator (flame polisher) Heat Bender


  3. #3
    Join Date
    Jul 2004
    Location
    Victor, NY
    Posts
    1,288

    Corel Paint

    Hi Chip;
    Sure.-assuming the pic has one good shoulder. Increase the canvas size on the original, select the "good" shoulder area and copy it. Mirror image the selection and paste it into the original. Move it around until it's in the right position and then use your brush and blur tools to visually merge the sections.
    Whole process should take no more than 1 min, 37 seconds.
    Best regards
    George
    Laserarts

  4. #4
    The actual comand to increase "canvas size" is Image ->paper size. Can just use center placement and enter new paper size in the box. Then edit as George suggests, or just clone a few pixels if it is just a bit cut off. Then you can crop it back as needed to minimum paper size.

Similar Threads

  1. Corel Question
    By George M. Perzel in forum Laser Engraving General Topics
    Replies: 7
    Last Post: 12-18-2007, 10:34 AM
  2. Corel Outline Question...
    By Mark Koenig in forum Laser Engraving General Topics
    Replies: 11
    Last Post: 06-26-2007, 9:07 PM
  3. Font Size question in Corel
    By Scott Shepherd in forum Laser Engraving General Topics
    Replies: 8
    Last Post: 06-05-2007, 3:58 PM
  4. How Too in Corel Draw 12
    By Hale Reider in forum Laser Engraving General Topics
    Replies: 5
    Last Post: 03-16-2006, 11:13 PM
  5. Corel Question...
    By SteveKrim in forum Laser Engraving General Topics
    Replies: 3
    Last Post: 02-21-2004, 9:46 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •