Results 1 to 1 of 1

Thread: Scottrat dovetail and tenon machine

  1. #1

    Scottrat dovetail and tenon machine

    I wanted to share my version of the Woodrat. I took what I liked from the original and modified it to be more ridgid and precise. It is currently set-up to cut tenons. The jig does everything the original does just more precisely. The east west axis was upgraded to a linear guide off a CNC machine (1" square) the cutting range was expanded to 36 inches in the east west. The north south and the router are straight off the woodrat. The dust collection is through the 8020 housing. I use the woodpecker flip clamps to stop the est west travel to cut the tenon length repeatably and quickly. The digital scale gives precise readings for tenon width and placement. This makes set-up quick...but I use stops after I dial it in.

    I use festool clamps in the Incra t-track to clamp the wood for machining.
    Attached Images Attached Images

Similar Threads

  1. Tenon and Dovetail saws???? Lie Neilsen vs. Adria??
    By Mark Singer in forum Neanderthal Haven
    Replies: 43
    Last Post: 01-19-2017, 9:38 AM
  2. The Haunched and Drawbored Mortise and Tenon Part II
    By Bob Smalser in forum Neanderthal Haven
    Replies: 14
    Last Post: 07-18-2011, 3:48 PM
  3. Mortise & Tenon OR Sliding Dovetail???
    By joseph j shields in forum General Woodworking and Power Tools
    Replies: 8
    Last Post: 12-26-2006, 10:22 PM
  4. Dovetail Tenon for Chuck
    By Curt Fuller in forum Turner's Forum
    Replies: 8
    Last Post: 05-11-2006, 10:24 PM
  5. Sliding Dovetail or Mortise/Tenon
    By Tom Conger in forum Design Forum
    Replies: 16
    Last Post: 12-10-2005, 9:19 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •