G'day all,
Omnisign Plus Pro 200
(Same as Rabbit HX40A)
Newlydraw software.
For some reason I am unable to engrave on the left hand side of the table. Can anyone help. This is driving me mad as it restricts the size of Items I can engrave.
Matt
G'day all,
Omnisign Plus Pro 200
(Same as Rabbit HX40A)
Newlydraw software.
For some reason I am unable to engrave on the left hand side of the table. Can anyone help. This is driving me mad as it restricts the size of Items I can engrave.
Matt
Matt, does it look like you are losing power the further over you go on the table? If so, it sounds like you need to align the laser beam on your system. Make sure the laser beam is going through the middle of all of the optics. I use masking tape to do my alignments. Burn a hole in the tape, then move the carriage to another area and burn the tape again. Try to get all of the burn marks to overlap across the motion of the table.
Rob,
It isn't an alignment problem. It is just that I can't get the head to travel across to the left hand side of the table.
could it have something to do with your page size/setting on your computer?
Epilog mini 24 with 45 watts
X3
More wood working tools then I deserve
Thanks Thad
I'll Give it a go.
Matt