Any rotary engravers here...?

[Ed Newbold]

In addition to my ULS M-300 laser engraver, I have acquired a used New Hermes ITF-V Pantograph in good condition. Unfortunately, there are no manuals with the thing.

While I probably can figure out most of the stuff, there are probably some good tips in the original manuals that would speed up the learning process.

Does anyone here know of on-line information or a group that might be able to lend me some insight about the machine?

Thanks very much,

[Darren Null]

Found a manual on ebay:
http://cgi.ebay.com/ws/eBayISAPI.dll...%3D4%26ps%3D42

[Vicky Orsini]

The first thing I learned was ... the bigger the number, the smaller the font.

[Mike Null]

Ed

I have a hard copy which I will copy and send if you'll PM your address.

I also have a PDF of a general rotary engraver's manual I'll email. It is useful but not specific to your machine.