Is there any problem with using the flexible aluminum dryer vent hose in a dust collector system?
Is there any problem with using the flexible aluminum dryer vent hose in a dust collector system?
Depends on how powerful your DC is. My system would crush it flat in less than a second.
Also, the chips from the jointer and planer would wear away at the corners and eventually blow out that area... which is cool to watch (damhikt).
mike
My 1 1/2HP delta has a 7" inlet and I hooked it up with a 5' section of the all aluminum flex they sell at HD. This is the stiff stuff, not super flexible. It went to a reducer to 6" and off to the tools. Worked fine for several years till I moved. It allowed me to move it around a bit when I needed to get behind the DC.
Rick Potter
I have mine running all over my shop and havent had any problems yet. It easy,flexible and cost a lot less than other stuff.
The other issue is how it impacts your air flow. Rigid piping will give you more power on your system and better airflow.