Results 1 to 3 of 3

Thread: spalted maple hollow form

  1. 06-30-2008, 4:11 AM #1
    mike fuson's Avatar
    mike fuson
    mike fuson is offline [OP] Member
    Join Date
    Feb 2007
    Location
    Siler,Kentucky
    Posts
    485

    spalted maple hollow form

    This one measures 4x8 with an antique oil finish. The spalting really added a lot to just an ordinary chunk of maple.



    865 miles southeast of Steve Schlumpf.
    Reply With Quote Reply With Quote
  3. 06-30-2008, 11:34 AM #2
    curtis rosche's Avatar
    curtis rosche
    curtis rosche is offline Member
    Join Date
    Jan 2008
    Location
    Paradise PA
    Posts
    3,098
    is this the same as the other one? they both look great!
    14x48 custom 2hp 9gear lathe
    9 inch pre 1940 craftsman lathe
    36 inch 1914 Sydney bandsaw (BEAST)
    Wood in every shelf and nook and cranny,,, seriously too much wood!
    Reply With Quote Reply With Quote
  4. 06-30-2008, 12:35 PM #3
    Bernie Weishapl's Avatar
    Bernie Weishapl
    Bernie Weishapl is offline Contributor
    Join Date
    Jan 2005
    Location
    Goodland, Kansas
    Posts
    22,605
    Mike that is beautiful. Yes the spalting does add a lot to it. Well done.
    Bernie

    Never put off until tomorrow what you can do the day after tomorrow.
    To succeed in life, you need three things: a wishbone, a backbone and a funnybone.


    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Similar Threads

  1. maple hollow form
    By mike fuson in forum Turner's Forum
    Replies: 11
    Last Post: 07-21-2007, 9:51 PM
  2. Ambrosia Maple hollow form
    By Travis Stinson in forum Turner's Forum
    Replies: 17
    Last Post: 07-11-2006, 10:29 AM
  3. Hard Maple Hollow Form
    By Jim Ketron in forum Turner's Forum
    Replies: 21
    Last Post: 04-16-2006, 12:39 AM
  4. Natural Edge Maple Burl Hollow Form
    By Dominic Greco in forum General Woodworking and Power Tools
    Replies: 12
    Last Post: 06-28-2004, 11:58 PM
  5. Box Elder Hollow Form
    By Dominic Greco in forum General Woodworking and Power Tools
    Replies: 14
    Last Post: 05-28-2004, 12:56 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules