Results 1 to 3 of 3

Thread: Need advice - positioning for small TS motor

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. #1
    Join Date
    Feb 2008
    Location
    Comox, BC, CANADA
    Posts
    249

    Question Need advice - positioning for small TS motor

    Hello All;

    I made a nice score over the weekend and pickup up a real tiny table saw. The name on it is Beaverline, Callander. It is identical to the one shown in the link below.

    http://www.owwm.com/PhotoIndex/detail.aspx?id=1358

    My question is, I have to build a new table base for it as the current one is shot, mine is setup exactly like the one in the link, except the motor cantilevers off the back on a big hinge so the weight of the motor creates the tension in the belt, so do I have to keep the TS itself raised on a block of wood in relation to the motor, or can the TS mount to the new base same as the motor?

    Thanks
    Last edited by Shawn Honeychurch; 07-02-2008 at 1:06 PM.
    No matter where you go, there you are. B. Banzai

Similar Threads

  1. Oh no I won the auction. What do I do now?
    By John Shuk in forum General Woodworking and Power Tools
    Replies: 33
    Last Post: 01-14-2005, 1:36 PM
  2. Compressor Motor Question
    By Joe Scarfo in forum General Woodworking and Power Tools
    Replies: 0
    Last Post: 12-18-2004, 12:48 PM
  3. Intro and BS replacement motor advice
    By Jim Hinze in forum General Woodworking and Power Tools
    Replies: 18
    Last Post: 08-21-2004, 8:27 AM
  4. Need motor advice
    By Dave Malen in forum General Woodworking and Power Tools
    Replies: 4
    Last Post: 03-20-2004, 1:16 PM
  5. Did I Ruin my Bandsaw?
    By Diane Maluso in forum General Woodworking and Power Tools
    Replies: 14
    Last Post: 10-21-2003, 7:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •