Results 1 to 4 of 4

Thread: Push to open drawer slides?

  1. #1
    Join Date
    Feb 2007
    Location
    Madison, Wi
    Posts
    51

    Push to open drawer slides?

    Does anyone know of a source for a drawer slide where it pops ajar with a push? I'm building a table with a drawer, and ripped the face apron, cut it, and saved the cut out so the drawer grain matches exactly. I'd prefer not to put a pull on the drawer which would detract from the grain. 90 minutes of web search only turned up British and Australian sources. Anyone used these, and where did you get them?

  2. #2
    Join Date
    Mar 2003
    Location
    San Francisco, CA
    Posts
    10,304
    www.cshardware.com has them. They call them Push & Rebound. They look like the standard sidemount ball-bearing slides, but with the extra machinery built in. They have 'em in 2" increments from 12" to 28". I'd give you a direct link, but I can't navigate their site. You can search with part number GS.4060.XX, where XX is the length you want in inches.

    There are also drawer pushers. http://wwhardware.com/catalog.cfm/Pr...D/BX1021%20L32 is one example.

    And Blum now has a push-to-open add-on for their Tandem slides. They call it Tip-On. Knowing Blum, I'd expect them to work well. Look at the bottom of this page: http://wwhardware.com/catalog.cfm/Gr...ll%20Extension
    Last edited by Jamie Buxton; 09-02-2008 at 12:50 AM.

  3. #3
    Join Date
    Feb 2007
    Location
    Madison, Wi
    Posts
    51
    Thanks Jamie - this helps a lot.

  4. #4
    Join Date
    Nov 2003
    Location
    Cave Creek, AZ - near Phoenix
    Posts
    1,261
    Rockler has several versions:

    http://www.rockler.com/product.cfm?sku=135&cs=1
    Dave Falkenstein aka Daviddubya
    Cave Creek, AZ

Similar Threads

  1. Wooden drawer slides versus metal drawer slides
    By wallace chapman in forum General Woodworking and Power Tools
    Replies: 29
    Last Post: 03-23-2009, 1:51 PM
  2. Double up drawer slides
    By Dan Stuewe in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 04-15-2008, 10:54 PM
  3. Drawer slides
    By Joe Vee in forum General Woodworking and Power Tools
    Replies: 5
    Last Post: 01-11-2008, 6:40 PM
  4. Drawer bottoms w/ undermount slides
    By Sam Shank in forum General Woodworking and Power Tools
    Replies: 7
    Last Post: 08-23-2006, 10:52 AM
  5. Drawer Slides
    By Jerry Bittner in forum General Woodworking and Power Tools
    Replies: 2
    Last Post: 08-29-2005, 8:40 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •