Red-Yellow Laserable Plastic?

[Bill Jermyn]

Does anyone know of a supplier of laserable 1/16 plastic, yellow with a red core?

[Joe Pelonio]

Rowmark and IPI will custom-make whatever you want. Rowmark 922-607 is the opposite, unfortunately, and IPI has no such combination off the shelf.

Try e-mailing Rowmark at

customerservice@rowmark.com


and for custom IPI plastics contact a local dealer.

For a small job I'd merely spray yellow Krylon Fusion onto white with the red core.

[Bill Jermyn]

Thanks, Joe. I'd do that but I only need a couple of quarter sheets. I think their minimum is 8 or 10 sheets.

[Doug Bergstrom]

Just reverse etch the Rowmark.

[Gary Hair]

Thanks, Joe. I'd do that but I only need a couple of quarter sheets. I think their minimum is 8 or 10 sheets.

Last time I checked their minimum was either 1 or 2 sheets. I think 8/10 was from a long time ago.

Gary

[Tony Lenkic]

Bill,

New Hermes has that combination in regular matte Gravoply 2. It lasers OK (the cap is thin).
Part No. 238-226

You can get this from Engravers Depot in Mississauga, On.

[Bill Jermyn]

Thanks, I'll give that a try