I Need some CNC work Done

[Ed Hazel]

I am looking to have some CNC work done. I basically have an oval that is 19.25" x 10", the smaller oval inside is 8.5" x 5.5" and is on the horizontal center line and the top of the small oval is 1.5" from the top of the big oval. I can send a tracing of it.

I would like two of these I will be using them for a pattern for a pin router. I thinking either using 3/8 HDPE or 1/2 MDF. I can supply either or if you have something that would work for this that would be ok also.

You may PM price ect.

[Steve Stram]

Ed,

I am in Trenton Michigan and could make them if you don't find someone closer. I have 1/2" MDO on hand.

Driving to get them or shipping them could be more than the parts. Let me know if you get down on my part of the state.

Steve.