Hello,
I have the Grizzly 15 inch planer and I've been struggling to get the indeed wing level with the planer bed. I've lowered the bed rollers so that they are not in play. It seems to me that the infeed wing is sagging even when fully tightened. That is: when I have the front edge of the infeed wing level with the planer bed, the back edge of the wing is almost a 1/4 inch lower than the planer bed (photo attached). This doesn't seem right at all… Would appreciate any advice from others who have this planer.. Note in the picture the level is being used only as a straight edge (my floor is not level).
Thanks very much,
Izzy