|
|
|
|||||||
| Register | Blogs | FAQ | Members List | Social Groups | Calendar | Search | Today's Posts | Mark Forums Read | SHOP | Donate |
 |
|
|
Thread Tools | Display Modes |
|
#1
11-27-2009, 1:44 PM
|
|||
|
|||
|
Cast iron miter box $12.50 + Shipping
Alright, time to clear this one off the bench.
I always thought this was a Stanley, but I can't seem to find a single makers mark. The only markings are " Made in USA" and the angle degree markings. It is in good shape, about 90% japanning. Everything moves as it should, and smoothly. Positive stops for 90, 45 and 22.5 degree angles. It has a movable stop which can be switched side to side. The saw I have for it is not the right saw. In fact, it is an inferior saw, with a loose tote, rather dull, and not quite the right size. It does work with the box for very small moldings, but I don't think I would want to cut anything over an inch with it. $12.50 + Shipping
__________________
King of the run-on sentence, ellipses, quotations and parentheses; master of the art of making a two word sentence last longer than a Victor Hugo novel, emperor of reiteration, redundancy and repetition. . .I could go on, but I will keep this brief. www.HighQualityCabinets.com Last edited by Matt Evans; 11-27-2009 at 1:46 PM. 
|
|
Ad Sponsored by Google
Ad Sponsored by Google
|
|
|
|
#2
11-27-2009, 7:59 PM
|
|||
|
|||
|
Sold, Pending payment.
__________________
King of the run-on sentence, ellipses, quotations and parentheses; master of the art of making a two word sentence last longer than a Victor Hugo novel, emperor of reiteration, redundancy and repetition. . .I could go on, but I will keep this brief. www.HighQualityCabinets.com
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
