Search:

Tag: hinges

Search: Search took 0.00 seconds.

  1. Need help sourcing hinges

    Started by Patrick Harper, 07-30-2016 5:53 PM
    butt hinges, hinges, mortise hinges
    • Replies: 8
    • Views: 1,922
    Last Post: 08-01-2016 7:41 AM
    by Mark Wooden  Go to last post
    • Replies: 3
    • Views: 1,409
    Last Post: 12-17-2014 9:35 AM
    by Mike Wilkins  Go to last post

    Forum:
    Design Forum

    • Replies: 1
    • Views: 2,389
    Last Post: 07-15-2014 9:42 PM
    by Tom Sontag  Go to last post

    Forum:
    Design Forum

  2. Help, Doors won't close

    Started by earl wojciechowski, 05-25-2013 12:09 PM
    • Replies: 10
    • Views: 1,980
    Last Post: 05-26-2013 11:57 AM
    by Ellen Benkin  Go to last post
  3. HELP!!! Which hinges? Cabinet door very close to drawers.

    Started by Lester Sak, 04-13-2013 11:52 AM
    3 Pages
    1 2 3
    • Replies: 33
    • Views: 8,576
    Last Post: 04-25-2013 3:55 PM
    by Lester Sak  Go to last post
  4. Hardware/hinges for a large mirrored medicine cabinet

    Started by Victor Robinson, 08-29-2012 2:47 AM
    2 Pages
    1 2
    • Replies: 22
    • Views: 10,718
    Last Post: 09-01-2012 2:45 AM
    by Victor Robinson  Go to last post
  5. The Epic Launch

    Started by ian hawthorne, 08-19-2012 1:45 PM
    • Replies: 6
    • Views: 2,680
    Last Post: 08-21-2012 7:27 PM
    by Mark Valsi  Go to last post
  6. Newbie Help

    Started by Michelle Halford, 10-24-2011 6:55 PM
    • Replies: 11
    • Views: 2,889
    Last Post: 11-03-2011 5:46 PM
    by Michelle Halford  Go to last post
  7. General Metalworking Tie Rod Ends used as hinge Question

    Started by raul segura, 08-09-2011 1:32 AM
    2 Pages
    1 2
    • Replies: 17
    • Views: 7,841
    Last Post: 11-02-2011 3:29 AM
    by raul segura  Go to last post

    Forum:
    Metalworking

  8. Seeking source for "Krenov Style" hinges

    Started by Stephen Edwards, 02-18-2010 4:29 PM
    hardware, hinges, krenov
    • Replies: 5
    • Views: 2,963
    Last Post: 02-18-2010 11:25 PM
    by Stephen Edwards  Go to last post
Results 1 to 10 of 10