Had a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Robert M Richardson Today, 10:44 AMI have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Brian Elfert Today, 9:49 AMI have a Laguna 14BX 2.5hp 14" bandsaw and a 3/4" Resaw King blade which was bought together with the bandsaw. It works very well and the 3/4" Resaw King blade cut very well although I don't have much experience with bandsaw and don't know how well other bandsaw cut. However, there is always a...
Last Post By: John TenEyck Today, 3:10 PMOne of the things I enjoy about wood working is the potential to learn new skills that enhance my over all enjoyment of the craft. As a Neander, often these new skills don't require an extensive investment in new tools. I've been a hand tool wood worker for >40 years and early on everything...
Last Post By: Ben Ellenberger Today, 3:42 PMAfter last year's trip to this part of the country, a second trip is needed. Total trip recap is in this thread from 2023. https://sawmillcreek.org/showthread.php?301671-Looking-for-some-travel-tips-SC-TN-KY-WV I’m planning this second trip for the fall. I have about 16 days/nights I can be gone...
Last Post By: Michael Drew Today, 2:47 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
My only concern with tool rolls is if they might retain moisture.
Otherwise it is based on what works best for you.
A lot of
This could be the start of a challenge! Try something new and post the results - perfection is not expected.
I just thought of something
I’ve got a couple and think they are nice. They are well made and have good quality canvas. I haven’t put them to heavy use and don’t
Ben Ellenberger Today, 3:38 PMBuy a 120/240 "control transformer" from the usual suspects. Buy some 240 volt LED bulbs for the task lights.
Bill D
Has any one tried the LV canvas chisel and gouge storage roll? Does meet your need?
I think I need a storage solution somewhat safer than
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 10:02 AM