I have a 2019 Grasshopper mower with Kubota D902 engine that suddenly won't start at low throttle. I have always started it at the lowest throttle setting and it started just fine. Now, it simply won't start at the lowest throttle setting. I thought something was seriously wrong, and I was just...
Last Post By: Jim Becker Yesterday, 7:52 PMOne of the things I enjoy about wood working is the potential to learn new skills that enhance my over all enjoyment of the craft. As a Neander, often these new skills don't require an extensive investment in new tools. I've been a hand tool wood worker for >40 years and early on everything...
Last Post By: Maurice Mcmurry Yesterday, 8:33 PMHi, I'm new to the forum. I'm 78 and have been using a Craftsman 10 inch 113.298051 for the last 39 years to build furniture for my house and various projects. I never upgraded until now because the craftsman could do what I needed and I didn't want to spend the money. Last week the fence wouldn't...
Last Post By: Maurice Mcmurry Yesterday, 8:47 PMI'm going to build some built-in bookcases in my house. The complicating factor is that the ceiling is 10' high. Of course, many have suggested I make some cabinets on the bottom half and then put shelves above so that the shelves would be 8' tall or shorter, but I don't want that; I want all open...
Last Post By: Tom Bender Yesterday, 9:18 AMWednesday, the LOML and I will comence traveling through the State of Washington to Vancouver Island BC. Our travels take us through the Tri Cities, Yakima, Mount Vernon, Vancouver Island, Port Angeles, and down to Portland. Does anybody know of sources on that general path where we might find...
Last Post By: John C Bush Yesterday, 9:58 PMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
If the recess is deep, i do what you describe - build boxes and screw on with trim screws. If the stool is already built out, you can just use individual
stephen thomas Yesterday, 11:45 PMI've seen threads discussing the pros and cons of straight-sided versus bevel-sided mortise chisels. The big takeaways seem to be
1. Straight sides
Is the trim to be painted? This would make the trim easier as caulking could help. I would cut the tapers and assemble the casing and the tapers. I have
Bradley Gray Yesterday, 11:00 PM
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Yesterday, 5:52 PM