My doc tells me I need an neck MRI to diagnose some arm pain that may be starting in the neck. On the phone the MRI facility asked me if I had ever been involved with "metal grinding". Of course as a woodworker I've sharpened tools on a wheel, drilled holes in metal etc. I'm hoping to get more...
Last Post By: Alan Lightstone Today, 8:08 AMAt least one that looks better than this? I think I can build something a little bit better than that plastic blister pack... Maybe take a plan from Paul Sellers Masterclasses, and build a case? and.. Will have to change a couple sizes...
Last Post By: steven c newman Today, 12:48 PMI just ordered a dozen pencil sharpeners for 12$ from Amazon. These should last me through the small project I have on the back burner.:D
Last Post By: Steve Demuth Today, 6:27 PMWell, I made the mistake of having my leaf blower repaired two years ago and it will not start this season, OH well. Note to self don't repair these things. Anybody use battery operated leaf blowers and how do you like them? Thanks. Brian
Last Post By: Edward Weber Today, 11:26 AMI have needed a long measuring tool that is rigid for checking square on doors (measuring the diagonals). I bought this a bit reluctantly because it is in three pieces and I don’t normally trust rulers that come apart. This is dead-on accurate and the joints where it comes together are precision...
Last Post By: Andrew Hughes Today, 7:39 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
If you can slide the headstock to the end of the lathe, you should be able to directly face the bowl you're turning.
Brice Rogers Today, 10:54 PMIf it was me, I would use 2 similar size wedges, place them parallel but on opposite sides of the arbor (capture the arbor shaft between them) and gently
Ken Fitzgerald Today, 10:29 PMOn the smaller table, there isn't a visible rail for the middle of the top to glue to. I generally attach the top with glue at the middle of the endgrain
Jamie Buxton Today, 10:26 PMNormally with "Sulphur" water air injection can work or a holding tank that's not pressurized and vents to atmosphere will allow the gas to
Ronald Blue Today, 10:13 PMHi All,
Hoping this is the right forum as I have a bench grinder for turning. One of the CBN wheels on my bench grinder won't come off. I
Those proud of their workshops, please post pics!
Thread Starter: Matt LauI'll finally be non-nomadic, and I'd like to finally build up a workshop. Before I get started, I'd love to get ideas. I'd love to see how you do things, and how you do things differently with all the disciplines here: tuners, neanders, power tool users, festoolies, etc. For those of you who...
Last Post By: Gerald Etto Today, 9:14 PM