Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 5:04 PMSaw this today while reading a story about the prospect of electrical distribution networks failing due to heat: When I mentioned to Candy that transformers don't "slow down" high voltage, but "step down" high-voltage to a lower voltage, she said, "it's just semantics." Though it seems...
Last Post By: Lee DeRaud Today, 2:09 AMPlease, this is not a question asking how to best sharpen hand tools, it is a simple question to ceramic stone users. How hard are they to maintain? My diamond plates are years old and do not cut as aggressively as in the past. I have a selection of water stones of known and unknown grit for...
Last Post By: John C Cox Yesterday, 4:35 PMHad a 7.5 baldor, had a seperate post on this because I thought I figured out what was going on but evidently this is beyond my knowledge or experience. I replaced caps on 7.5 baldor, no difference, bought new leeson 7.5 hp, both single phase motors, got it hooked up, check wiring, cranked...
Last Post By: Michael Schuch Yesterday, 11:31 PMLooking to upgrade from my old 6" Jet JJ-6cs jointer (which I put a helical head on). I just have a hobby shop for personal use but would like to get an 8" jointer since I find the 6" too small. I've for the most part settled on Grizzly for their affordability and overall good reviews. G0490ZX:...
Last Post By: Warren Lake Yesterday, 10:23 AMBeen doing it like (or equivalent) this for years. (Votes: 4)
Wow! Never thought of that. (Votes: 0)
Been doing it with mirrors. (Votes: 2)
Ain't got a boat, truck, care… (Votes: 0)
It's threads like this that keep me on the edge of the "sell or keep" fence.
I have an older single speed 690 that I haven't used
Very nice, but were I a cat I'd lurk under the Hostas, and now under the table.
Tom Bender Today, 7:14 AMHi John
The rooster varies in many details from a real bird but is without a doubt a rooster. Fritz had the artistic ability to speak clearly in
I had seven 690's and am down to two, let me know your thoughts, been thinking of picking one up to try myself. Down to 3 3102's from 9, and I would like
Larry Edgerton Today, 6:24 AMNMI..
Make sure what ever you decide on - fits the router plate in the table.
Not all hole patterns are going to match up.
if
Left lane
Thread Starter: Ole AndersonLord, give me patience and understanding for those folks that drive needlessly in the left lane. Amen
Last Post By: Mike Wilkins Yesterday, 11:09 PM